Cross-chain. Non-custodial. Seven chains.

Bridge between any of seven major chains.

Ethereum · Optimism · BNB Chain · Polygon · Base · Arbitrum · Avalanche

One transaction. Two chains. Done.

1. Pick the asset and source chain.
2. Pick the destination chain.
3. Sign the transaction in your wallet.
4. Receive the bridged token in your wallet on the destination chain.

No one holds your funds in between.

Most bridges support a small number of chain pairs. If you bridge between five chains, you end up using two or three different bridge apps.

GIDEX Bridge covers seven major chains in one interface. Same wallet, same flow, no Ginox-held balance during the bridge.

How non-custodial cross-chain bridging actually works

Bridges have a deserved reputation as one of the riskier parts of DeFi. The reason is that historically many bridges custodied user funds during the bridge process. The asset went into a bridge contract on the source chain, the bridge operator confirmed it, then issued the bridged asset on the destination chain. If the bridge operator was compromised, user funds were at risk.

Non-custodial bridges work differently. The asset on the source chain gets locked or burned in a contract you can verify. The bridged asset on the destination chain gets minted to your wallet automatically based on on-chain proof of the source-chain action. No bridge operator holds your funds during the process.

GIDEX Bridge uses non-custodial bridge mechanisms throughout. There is no Ginox-controlled wallet holding your assets at any point in the bridge process. The bridged asset shows up in your wallet on the destination chain as a direct result of the on-chain mechanism, not a Ginox employee processing your withdrawal.

That said, bridging crypto is still inherently riskier than trading on a single chain. Always verify the destination chain and receiving address before you sign. Bridges have been exploited historically, and even non-custodial designs can have smart contract risks.

When to bridge versus swap

Bridge is for moving the same asset between chains. Swap is for converting one asset into another on the same chain.

If you have ETH on Ethereum and want ETH on Arbitrum, that is a bridge.

If you have ETH on Arbitrum and want USDC on Arbitrum, that is a swap.

GIDEX does both, and which one you need depends on what you are trying to do. For moves where you want to change both the chain and the asset, you typically bridge first and swap second, or use the right combination depending on which side has better liquidity.

Common questions

What is the best multichain bridge?

The best crypto bridge supports the chains you actually use, keeps you in custody, and gets the bridged token to the destination chain reliably. GIDEX Bridge covers seven major chains (Ethereum, Optimism, BNB Chain, Polygon, Base, Arbitrum, Avalanche) in one interface with no Ginox-held balance in the middle.

Which chains does GIDEX Bridge support?

Ethereum, Optimism, BNB Chain, Polygon, Base, Arbitrum, and Avalanche. You can bridge between any of these.

How long does a bridge take?

Usually a few seconds to a few minutes, depending on the source and destination chains.

Where does the bridged token go?

Directly into your wallet on the destination chain.

What does GIDEX Bridge cost?

A small bridge fee plus network gas on both chains. The full cost is shown before you confirm.

Is GIDEX Bridge safe?

There is no Ginox-controlled wallet holding your funds during the bridge. The bridge runs through on-chain mechanisms. Always verify the destination chain and address before signing.

Risk disclosure

Bridging crypto has its own risks beyond price risk. Bridge mechanisms can fail or get delayed in rare conditions. Always double-check the destination chain and the receiving address before signing. Never bridge funds you cannot afford to have stuck temporarily.